Hoop House Plastic Master Roll 36' × 2952'

Before you start:

• Store the roll horizontally, in its original packaging, in a cool shaded area until install.
• Do not drag the roll across the ground. After removing the packaging, inspect the roll, including both ends, for shipping damage. Photograph any damage and contact us before installing.
• Install on a mild day, with temperatures between 50–72°F (10–22°C).
• Arrange enough help for installation. Check the roll’s actual weight and packed dimensions, and use lifting equipment suitable for the load.
• Make sure the frame is clean, smooth and free of rust or sharp edges. Galvanized metal is preferred.

During installation:

1. Unroll each cover length while keeping the film folded. Then unfold it across the structure. Do not unroll and unfold at the same time.
2. Tension the film evenly, but not too tight. Flapping shortens film life, but over-tensioning can cause tears in cold weather.
3. Protect film-to-metal contact points with tape designed to protect greenhouse film from heat and abrasion. Check this protection regularly and replace it as needed.
4. Do not use sharp clamps or wire directly on the film — always cushion the contact so the film stays properly tensioned.

Chemicals and follow-up care:

• Keep pesticides and other chemicals off the film, especially products containing sulfur or halogens such as chlorine. Avoid direct contact with PVC pipes, clips and other PVC accessories.
• Ventilate well after chemical applications and avoid direct contact.
• Repair holes or tears promptly with greenhouse film repair tape. Do not use PVC tape.
• Check the film’s tension between seasons and after strong winds. Adjust it if needed, without over-tightening.